Auflistung nach Autor:in "Ebert, Martin"

Gerade angezeigt 1 - 3 von 3
  • Vorschaubild
    Publikation
    Chemical composition and mixing-state of ice residuals sampled within mixed phase clouds
    (Copernicus, 25.03.2011) Ebert, Martin; Worringen, Annette; Benker, Nathalie; Mertes, Stephan; Weingartner, Ernest; Weinbruch, Stephan [in: Atmospheric Chemistry and Physics]
    Abstract. During an intensive campaign at the high alpine research station Jungfraujoch, Switzerland, in February/March 2006 ice particle residuals within mixed-phase clouds were sampled using the Ice-counterflow virtual impactor (Ice-CVI). Size, morphology, chemical composition, mineralogy and mixing state of the ice residual and the interstitial (i.e., non-activated) aerosol particles were analyzed by scanning and transmission electron microscopy. Ice nuclei (IN) were identified from the significant enrichment of particle groups in the ice residual (IR) samples relative to the interstitial aerosol. In terms of number lead-bearing particles are enriched by a factor of approximately 25, complex internal mixtures with silicates or metal oxides as major components by a factor of 11, and mixtures of secondary aerosol and carbonaceous material (C-O-S particles) by a factor of 2. Other particle groups (sulfates, sea salt, Ca-rich particles, external silicates) observed in the ice-residual samples cannot be assigned unambiguously as IN. Between 9 and 24% of all IR are Pb-bearing particles. Pb was found as major component in around 10% of these particles (PbO, PbCl2). In the other particles, Pb was found as some 100 nm sized agglomerates consisting of 3–8 nm sized primary particles (PbS, elemental Pb). C-O-S particles are present in the IR at an abundance of 17–27%. The soot component within these particles is strongly aged. Complex internal mixtures occur in the IR at an abundance of 9–15%. Most IN identified at the Jungfraujoch station are internal mixtures containing anthropogenic components (either as main or minor constituent), and it is concluded that admixture of the anthropogenic component is responsible for the increased IN efficiency within mixed phase clouds. The mixing state appears to be a key parameter for the ice nucleation behaviour that cannot be predicted from the sole knowledge of the main component of an individual particle.
    01A - Beitrag in wissenschaftlicher Zeitschrift
  • Vorschaubild nicht verfügbar
    Publikation
    Counterflow virtual impactor based collection of small ice particles in mixed-phase clouds for the physico-chemical characterization of tropospheric ice nuclei. sampler description and first case study
    (Taylor & Francis, 07.09.2007) Mertes, Stephan; Verheggen, Bart; Walter, Saskia; Connolly, Paul; Ebert, Martin; Schneider, Johannes; Bower, Keith N.; Cozic, Julie; Weinbruch, Stephan; Baltensperger, Urs; Weingartner, Ernest [in: Aerosol Science and Technology]
    A ground-based sampling system named Ice-CVI is introduced that is able to extract small ice particles with sizes between 5 and 20 μ m out of mixed-phase clouds. The instrument is based on a counterflow virtual impactor (CVI) removing interstitial particles and is supplemented by additional modules that pre-segregate other constituents of mixed-phase clouds. Ice particles of 20 μ m and smaller are expected to grow only by water vapor diffusion and there is a negligible probability that they scavenge aerosol particles by impaction and riming. Thus, their residuals which are released by the Ice-CVI can be interpreted as the original ice nuclei (IN). In a first field test within the Cloud and Aerosol Characterization Experiment (CLACE-3) at the high alpine research station Jungfraujoch, the collection behavior of the single components and the complete system was evaluated under atmospheric sampling conditions. By comparing parameters measured by the Ice-CVI with corresponding results obtained from other inlets or with in-situ instrumentation it is verified that the small ice particles are representatively collected whereas all other mixed phase cloud constituents are effectively suppressed. In a case study it is observed that super-micrometer particles preferentially serve as IN although in absolute terms the IN concentration is dominated by sub-micrometer particles. Mineral dust (Si), non-volatile organic matter and black carbon could be identified as IN components by means of different chemical analyses. The latter suggests an anthropogenic influence on the heterogeneous ice nucleation in supercooled, tropospheric clouds.
    01A - Beitrag in wissenschaftlicher Zeitschrift
  • Vorschaubild
    Publikation
    Single-particle characterization of ice-nucleating particles and ice particle residuals sampled by three different techniques
    (Copernicus, 2015) Worringen, Annette; Kandler, Konrad; Benker, Nathlie; Dirsch, Thomas; Mertes, Stephan; Schenk, Ludwig; Kästner, Udo; Frank, Fabian; Nillius, Björn; Bundke, Ulrich; Rose, D.; Curtius, Joachim; Kupiszewski, Piotr; Weingartner, Ernest; Vochezer, Paul; Schneider, Johannes; Schmidt, S.; Weinbruch, Stephan; Ebert, Martin [in: Atmospheric Chemistry and Physics]
    In the present work, three different techniques to separate ice-nucleating particles (INPs) as well as ice particle residuals (IPRs) from non-ice-active particles are compared. The Ice Selective Inlet (ISI) and the Ice Counterflow Virtual Impactor (Ice-CVI) sample ice particles from mixed-phase clouds and allow after evaporation in the instrument for the analysis of the residuals. The Fast Ice Nucleus Chamber (FINCH) coupled with the Ice Nuclei Pumped Counterflow Virtual Impactor (IN-PCVI) provides ice-activating conditions to aerosol particles and extracts the activated particles for analysis. The instruments were run during a joint field campaign which took place in January and February 2013 at the High Alpine Research Station Jungfraujoch (Switzerland). INPs and IPRs were analyzed offline by scanning electron microscopy and energy-dispersive X-ray microanalysis to determine their size, chemical composition and mixing state. Online analysis of the size and chemical composition of INP activated in FINCH was performed by laser ablation mass spectrometry. With all three INP/IPR separation techniques high abundances (median 20–70%) of instrumental contamination artifacts were observed (ISI: Si-O spheres, probably calibration aerosol; Ice-CVI: Al-O particles; FINCH + IN-PCVI: steel particles). After removal of the instrumental contamination particles, silicates, Ca-rich particles, carbonaceous material and metal oxides were the major INP/IPR particle types obtained by all three techniques. In addition, considerable amounts (median abundance mostly a few percent) of soluble material (e.g., sea salt, sulfates) were observed. As these soluble particles are often not expected to act as INP/IPR, we consider them as potential measurement artifacts. Minor types of INP/IPR include soot and Pb-bearing particles. The Pb-bearing particles are mainly present as an internal mixture with other particle types. Most samples showed a maximum of the INP/IPR size distribution at 200–400 nm in geometric diameter. In a few cases, a second supermicron maximum was identified. Soot/carbonaceous material and metal oxides were present mainly in the sub-micrometer range. Silicates and Ca-rich particles were mainly found with diameters above 1 μm (using ISI and FINCH), in contrast to the Ice-CVI which also sampled many submicron particles of both groups. Due to changing meteorological conditions, the INP/IPR composition was highly variable if different samples were compared. Thus, the observed discrepancies between the different separation techniques may partly result from the non-parallel sampling. The differences of the particle group relative number abundance as well as the mixing state of INP/IPR clearly demonstrate the need of further studies to better understand the influence of the separation techniques on the INP/IPR chemical composition. Also, it must be concluded that the abundance of contamination artifacts in the separated INP and IPR is generally large and should be corrected for, emphasizing the need for the accompanying chemical measurements. Thus, further work is needed to allow for routine operation of the three separation techniques investigated.
    01A - Beitrag in wissenschaftlicher Zeitschrift