Malgaroli, Patrick

Profilbild
E-Mail-Adresse
Geburtsdatum
Projekt
Organisationseinheiten
Berufsbeschreibung
Nachname
Malgaroli
Vorname
Patrick
Name
Patrick Malgaroli

Filter

20232
Filter zurücksetzen

Einstellungen

Autor:in: de Wild, Michael ×

Suchergebnisse

Gerade angezeigt 1 - 2 von 2
  • Vorschaubild
    Publikation
    Effect of printing parameters on mechanical performance of material-extrusion 3D-printed PEEK specimens at the point-of-care
    (MDPI, 17.01.2023) Zarean, Paridokht; Zarean, Parichehr; de Wild, Michael; Thieringer, Florian M.; Sharma, Neha; Seiler, Daniel; Malgaroli, Patrick [in: Applied Sciences]
    Additive manufacturing (AM) of polyetheretherketone (PEEK) biomaterials using the material-extrusion (MEX) method has been studied for years. Because of the challenging manufacturing process, precisely controlling printing parameters is crucial. This study aimed to investigate the effects of printing parameters such as orientation and position of printing on mechanical properties. Thus, 34 samples were printed using PEEK filament and the MEX process. Samples were divided into two main groups (A,B) according to their printing orientations (A: groups 1–3) and positions on the build plate (B: groups 4–8). Mechanical tensile tests were performed to evaluate the effects of different printing orientations and positions on mechanical properties. The means of the tensile modulus in samples 3D-printed in XY (group 1), XZ (group 2), and ZX (group 3) orientations were not significantly different (p-value = 0.063). Groups 1 and 2 had smaller distributions than group 3 in the means of tensile strength. The t-test showed that the overall means of the measurements in groups 4–8 did not differ significantly (p-value = 0.315). The tensile tests indicated that printing in vertical and horizontal orientations had no significant influence on mechanical properties. There were no significant differences in mechanical strength between top/bottom printed samples in five different lateral positions. Reliability of printing with good mechanical properties could be a step forward to manufacturing patient-specific implants.
    01A - Beitrag in wissenschaftlicher Zeitschrift
  • Vorschaubild
    Publikation
    Three-dimensional printed hydroxyapatite bone substitutes designed by a novel periodic minimal surface algorithm are highly osteoconductive
    (Liebert, 2023) Maevskaia, Ekaterina; Khera, Nupur; Ghayor, Chafik; Bhattacharya, Indranil; Guerrero, Julien; Nicholls, Flora; Waldvogel, Christian; Bärtschi, Ralph; Fritschi, Lea; Salamon, Dániel; Özcan, Mutlu; Malgaroli, Patrick; Seiler, Daniel; de Wild, Michael; Weber, Franz E. [in: 3D Printing and Additive Manufacturing]
    01A - Beitrag in wissenschaftlicher Zeitschrift