Hemm-Ode, Simone

Profilbild
E-Mail-Adresse
Geburtsdatum
Projekt
Organisationseinheiten
Berufsbeschreibung
Nachname
Hemm-Ode
Vorname
Simone
Name
Hemm-Ode, Simone

Filter

2020 - 20212
Filter zurücksetzen

Einstellungen

Autor:in: Daeichin, Verya ×

Suchergebnisse

Gerade angezeigt 1 - 2 von 2
  • Vorschaubild nicht verfügbar
    Publikation
    Erratum to “Lamb waves and adaptive beamforming for aberration correction in medical ultrasound imaging”
    (IEEE, 02/2021) Mozaffarzadeh, Moein; Minonzio, Claudio; De jong, Nico; Verweij, Martin; Hemm-Ode, Simone; Renaud, Guillaume; Daeichin, Verya [in: IEEE Transactions on Ultrasonics, Ferroelectrics, and Frequency Control]
    In the above article [1] , we mentioned that the superposition of the different symmetric (S) modes in the frequency wavenumber (f-k) domain results in a high-intensity region where its slope corresponds to the longitudinal wave speed in the slab. However, we have recently understood that this high intensity region belongs to the propagation of a wave called lateral wave or head wave [2] – [5] . It is generated if the longitudinal sound speed of the aberrator (i.e., the PVC slab) is larger than that of water and if the incident wavefront is curved. When the incidence angle at the interface between water and PVC is near the critical angle, the refracted wave in PVC reradiates a small part of its energy into the fluid (i.e., the head wave). As discussed in [4] , if the thickness of the waveguide is larger than the wavelength, the first arriving signal is the head wave. This is also the case in our study [1] where the ultrasound wavelength of a compressional wave in PVC was close to 1 mm, and a PVC slab with a thickness of 8 mm was used.
    01A - Beitrag in wissenschaftlicher Zeitschrift
  • Vorschaubild nicht verfügbar
    Publikation
    Lamb waves and adaptive beamforming for aberration correction in medical ultrasound imaging
    (IEEE, 06.07.2020) Mozaffarzadeh, Moein; Minonzio, Claudio; de Jong, Nico; Verweij, Martin; Hemm-Ode, Simone; Daeichin, Verya [in: IEEE Transactions on Ultrasonics, Ferroelectrics, and Frequency Control]
    Phase aberration in transcranial ultrasound imaging (TUI) caused by the human skull leads to an inaccurate image reconstruction. In this article, we present a novel method for estimating the speed of sound and an adaptive beamforming technique for phase aberration correction in a flat polyvinylchloride (PVC) slab as a model for the human skull. First, the speed of sound of the PVC slab is found by extracting the overlapping quasi-longitudinal wave velocities of symmetrical Lamb waves in the frequency-wavenumber domain. Then, the thickness of the plate is determined by the echoes from its front and back side. Next, an adaptive beamforming method is developed, utilizing the measured sound speed map of the imaging medium. Finally, to minimize reverberation artifacts caused by strong scatterers (i.e., needles), a dual probe setup is proposed. In this setup, we image the medium from two opposite directions, and the final image can be the minimum intensity projection of the inherently co-registered images of the opposed probes. Our results confirm that the Lamb wave method estimates the longitudinal speed of the slab with an error of 3.5% and is independent of its shear wave speed. Benefiting from the acquired sound speed map, our adaptive beamformer reduces (in real time) a mislocation error of 3.1, caused by an 8 mm slab, to 0.1 mm. Finally, the dual probe configuration shows 7 dB improvement in removing reverberation artifacts of the needle, at the cost of only 2.4-dB contrast loss. The proposed image formation method can be used, e.g., to monitor deep brain stimulation procedures and localization of the electrode(s) deep inside the brain from two temporal bones on the sides of the human skull.
    01A - Beitrag in wissenschaftlicher Zeitschrift